ProcessMaker code contributions

Moderator: amosbatto

User avatar
By amosbatto
#824295
Turn on Debug Mode in your process properties, then use trigger code like this to set a variable:
Code: Select all
@@myVar = 'It executed';
Then check in the debugger if "myVar" was set.

The second way is to do this:
Code: Select all
print "It executed";
die();
You can also use G::SendMessageText().

Hi Support, I think this is good. I too have fixe[…]

Hi, I'm facing the same error and when I run : […]

Routing Logic

Hi All I am doing a process, where i have 3 tasks […]

Hi @amosbatto, thanks a lot. at least the message[…]