Ask questions about your install or get help installing and configuring ProcessMaker 2

Moderator: amosbatto

By Danielkhanu
#814918
Is there anyway i can manually configure LDAP (NOT using the interface but rather editing a config file). I am asking this because using the admin web tab is giving me problems without me knowing what is wrong. It basically tells me the binding is wrong but takes too long to give the error anytime a change is made. Would much rather edit files in the ini directly.

Any help is greatly appreciated.
Send for clarification

Cost: Will you be using PM entrerprise or open sou[…]

SMS Gateway

Hello natesh, I have a Get ready to use integrate[…]

delete information after CSV export

thanks for your attention, i have some change on y[…]

Thanx again amosbatto... I'll re-check file permis[…]