- Fri Sep 21, 2018 2:27 am
#816212
How did you send the email (there are 3 ways to send emails in PM) and what you see under Admin > Logs > Email?
If you are using PMFSendMessage() in a trigger, use a variable to get the return value:
@@ret = PMFSendMessage(...);
Then, you can check "ret" in the debugger, when Debug Mode is activated. If it is set to 0, then you have a problem in your code or you didn't correctly configure the account at Admin > Settings > Email Servers.
Post your trigger code if you can't figure it out.