- Mon Mar 14, 2016 11:25 am
#784853
According to the docs I have found our turn on debugging for a process :
1. Designer
2. select process
3. right mouse ->Enable Debug Mode
4. Edit the process selected
5. in empty space right mouse click and select Edit process
6. check the Debug check box
7. save
When I click all the right buttons and fill in the blanks it runs through it.
When I look at the item, in this case 'order', that was used to create it it has gone through the sub processes. I can see the 'Steps >>' flash then disappear and leave only the Information dropdown.
We have a duplicate setup for our production version, called stage. It works, but our production version does not. Is there maybe something that is turned off, some switch, that is turned off.
I've done a diff -r <prod>/workflow <stage>/workflow, Centos 7, and I do not find any differences.
[img]Screen%20Shot%202016-03-14%20at%2010.18.10%20AM[/img]
1. Designer
2. select process
3. right mouse ->Enable Debug Mode
4. Edit the process selected
5. in empty space right mouse click and select Edit process
6. check the Debug check box
7. save
When I click all the right buttons and fill in the blanks it runs through it.
When I look at the item, in this case 'order', that was used to create it it has gone through the sub processes. I can see the 'Steps >>' flash then disappear and leave only the Information dropdown.
We have a duplicate setup for our production version, called stage. It works, but our production version does not. Is there maybe something that is turned off, some switch, that is turned off.
I've done a diff -r <prod>/workflow <stage>/workflow, Centos 7, and I do not find any differences.
[img]Screen%20Shot%202016-03-14%20at%2010.18.10%20AM[/img]
- By joepaul