Questions, suggestions and discussion around ProcessMaker 3 documentation

Moderator: amosbatto

#813169
Hello,

The documentation covering the env.ini configiration file seems to be uncomplete:
http://wiki.processmaker.com/3.2/Config ... le_env.ini

1) I found that there are two locations where this file could be found:
a) in a global location i.e. /opt/processmaker/workflow/engine/config (as described in the documentation)
b) in a workspace-specific location i.e. /opt/processmaker/shared/sites/<workspace name>
However, the documentation does not describe the location b) and the relation between parameters set differently in files in those locations.

2) Some of the parameters that could be set in the env.ini (as shown in viewtopic.php?f=47&t=730020) are not documented, i.e.

expiration_year
system_utc_time_zone

Regards,
fibo2358
#813202
fibo2358 wrote:The documentation covering the env.ini configiration file seems to be uncomplete:
http://wiki.processmaker.com/3.2/Config ... le_env.ini

1) I found that there are two locations where this file could be found:
a) in a global location i.e. /opt/processmaker/workflow/engine/config (as described in the documentation)
b) in a workspace-specific location i.e. /opt/processmaker/shared/sites/<workspace name>
However, the documentation does not describe the location b) and the relation between parameters set differently in files in those locations.
The processmaker/workflow/engine/config/env.ini file is correct file for the system configuration.
Looking through the source code, it appears that solr uses an processmaker/shared/sites/<workspace>/env.ini file for its own configuration, but you should ignore it.
fibo2358 wrote:2) Some of the parameters that could be set in the env.ini (as shown in viewtopic.php?f=47&t=730020) are not documented, i.e.

expiration_year
system_utc_time_zone
I will file an issue report asking the Dev team if these settings should be documented.

I am having an issue with summing the values in a […]

Cancel Cases

Hello, I´m not sure if this would help with […]

Hello, The similar topic has been discussed here:[…]

Hi, Thank you, the documentation must have been u[…]