Questions and discussion about using ProcessMaker: user interface, running cases & functionality

Moderator: ArturoRobles

By jasonhocky
#827890
Hello guys,
I am trying to connect to ProcessMaker Community 3.3 by using OAuth2 grant_type code, I tried twice: in a Bitnami instance and in a Centos 7 fresh instance.
When OAuth2 flow is started, and after ProcessMaker requests user name and password I get redirected to the case list instead consent page, when retry (already logged in), it redirects to
CODE: SELECT ALL
https://mysite/workflow/oauth2/authorize?response_type=code&client_id=XXXXXXXX
but showing an error page (image attached).
Any one has had success using code grant type OAuth2 on a PM 3.3 ?
Thanks!
Jason
User avatar
By RicardoMG
#827935
Hello!

I didn't get any problems in version 3.3.4-community, I followed the steps in the ProcessMaker's documentation. I leave the link for you to review:
https://wiki.processmaker.com/3.1/OAuth_2.0

Best regards, Ricardo.
Manual email send out did not run.

Dear All, Sometimes email stuck in pending when p[…]

DELETE A OUTPUT DOCUMENT

I solve the problem using this trigger $caseId =[…]

First off I am new to processmaker. I am trying to[…]

Total of grid in integer

Hi, Is there any better way to do it instead of c[…]