- Mon Sep 18, 2017 4:12 am
#795629
hi,
i was using PM 3.0.8.1 (or 1.8 i am not sure) with bitnami installer. for some of problem i installed PM 3.2.1 with manual installation. but there is really big perfonmance issue with PM 3.2.1 . in the old version when i did something it cost 2 or 3 seconds but when i did same job with same system , it costs at least 10 sec. the 10 sec is not big deal. some of our job cost 10 - 15 second to open with old version. with new PM they can barely open in a minute. sometimes getting time out.
my system windows 64x ,
C:\opt\processmaker\shared\sites\workflow\db,
DB_HOST, DB_RBAC_HOST and DB_REPORT_HOST same ip adress with pros.conf,
i already searched forum and wikia , found just this one viewtopic.php?f=40&t=710005&p=789894&hi ... ce#p788986
and its not working well for me.
i was using PM 3.0.8.1 (or 1.8 i am not sure) with bitnami installer. for some of problem i installed PM 3.2.1 with manual installation. but there is really big perfonmance issue with PM 3.2.1 . in the old version when i did something it cost 2 or 3 seconds but when i did same job with same system , it costs at least 10 sec. the 10 sec is not big deal. some of our job cost 10 - 15 second to open with old version. with new PM they can barely open in a minute. sometimes getting time out.
my system windows 64x ,
C:\opt\processmaker\shared\sites\workflow\db,
DB_HOST, DB_RBAC_HOST and DB_REPORT_HOST same ip adress with pros.conf,
i already searched forum and wikia , found just this one viewtopic.php?f=40&t=710005&p=789894&hi ... ce#p788986
and its not working well for me.